Replacing the Printhead Cleaning Roll on the HP Jet Fusion 3D Printer | HP Jet Fusion | HP
Learn how to replace the printhead cleaning roll on the HP Jet Fusion 3D Printer. Your product might look different, but the steps are the same.
For other helpful videos go to http://hp.com/supportvideos or http://youtube.com/hpprintersupport.
More support options for your printer are available at http://hp.com/support.
Continue the Conversation:
http://hp.care/SupportForums
http://hp.care/FacebookSupport
http://hp.care/TwitterSupport
Follow these steps to replace the printhead cleaning roll on the HP Jet Fusion 3D Printer:
- On the printer’s front panel, touch Supplies, Printhead cleaning roll, and then Replace.
- Touch Start to begin the process.
- Open the agent door and the external cleaning-roll door.
- Unlock the internal cleaning-roll door with the safety key, and then open the door.
- Open the printer’s top cover.
- Detach the end of the cleaning roll from the core of the upper roll.
- Pull the black knob, located on the upper left of the cleaning roll, and turn the pinch system counterclockwise.
- Clean the rubber blade and the roll input with the remainder of the cleaning roll.
- Wind the remainder of the cleaning roll onto the lower axle.
- Remove the hub of the lower roll by pressing on the tab.
- Then remove the lower roll.
- Remove the hub on the upper roll, then remove the roll core and place it on the lower axle. Replace the hub.
- Place the upper hub onto the new roll, and then slide it onto the upper axle until it clicks into place.
- Pass the leading edge of the roll over the upper rollers, and thread the cleaning material through the rollers on the left.
- There is a strip of polyester film on the leading edge of the cleaning material.
- Insert it into the hole in the take-up core. The take-up core will pull in the cleaning material.
- Rotate the lower roll one full turn counterclockwise.
- Restore the pinch system by moving the black knob back into its original position.
- If you feel resistance when moving the pinch system, the cleaning roll might be too tight.
- Turn the roll counterclockwise to loosen the system.
- Close and lock the doors.
#HP #HPSupport #HPJetFusion
SUBSCRIBE: http://bit.ly/PrinterSupport
SHOP NOW: http://store.hp.com/us/en/
About HP:
HP Inc. creates technology that makes life better for everyone everywhere — every person, every organization, and every community around the globe. Through our portfolio of printers, PCs, mobile devices, solutions, and services, we engineer experiences that amaze.
Connect with HP:
Visit HP WEBSITE: http://www.hp.com
Like HP on FACEBOOK: https://www.facebook.com/HP
Follow HP on TWITTER: https://twitter.com/HP
Follow HP on INSTAGRAM: https://www.instagram.com/hp
Follow HP on LINKEDIN: https://www.linkedin.com/company/hp
This video was produced by HP.
Replacing the Printhead Cleaning Roll on the HP Jet Fusion 3D Printer | HP Jet Fusion | HP
https://www.youtube.com/user/HP
ConversionConversion EmoticonEmoticon